“The alfalfa weevil probably is the No. 1 (insect) pest for alfalfa in Wyoming,” Scott Schell, assistant extension entomologist for the University of Wyoming, said Tuesday at the High Plains Crop Convention in Torrington.
This item is available in full to subscribers.
To continue reading, you will need to either log in to your subscriber account, below, or purchase a new subscription.
Please log in to continue |
TORRINGTON – “The alfalfa weevil probably is the No. 1 (insect) pest for alfalfa in Wyoming,” Scott Schell, assistant extension entomologist for the University of Wyoming, said Tuesday at the High Plains Crop Convention in Torrington.
In his presentation, Schell explored integrated pest management, including a six-step approach to battling the bug.
“At UW, we use integrated pest management … multiple approaches,” he said, adding complete eradication is unrealistic.
“Management is the goal,” he said. “To keep damage below the economic injury level.”
Step 1: Know your enemy
The alfalfa weevil was first introduced to the U.S. about 95 years ago, Schell said. There are two strains: eastern and western. Wyoming is home to the western strain, however, it is near the border of where eastern alfalfa weevils are found.
“They have four stages, or instars, from egg to adult,” Schell explained. “The thirds and fourths are bright green with a white stripe down the back” and the insects range in size from one to two millimeters at stage 1, to approximately 3/8-inch when fully grown.
Step 2: Learn pest and host lifecycle and biology
Each female alfalfa weevil is capable of laying between 400 to 1,000 eggs, though not all at once, Schell said.
“There is a certain threshold temperature to start their development – for the alfalfa weevil, it’s 48 degrees, for alfalfa growth itself, it is 42 degrees,” he said.
Each day that meets the temperature threshold is known as a “degree day.” It takes between 300 to 310 degree days for weevil eggs to hatch, and “noticeable visual damage to alfalfa plants occur by (degree day) 375.”
Producers can access a degree-day calculator at www. pnwpest.org/NW/ddmaps.html.
“It can help tell you when to start sampling your field,” Schell said. “Start scouting at (degree day) 375; peak second instar occurs at (degree day) 425.”
Step 3: Monitor or sample environment for pest population
Schell said producers should take note of several circumstances, including whether the pest is present or absent, if it’s distributed all over the field or only in certain areas, and whether its population numbers appear to be increasing or decreasing.
See the box for Schell’s explanation of how to use the “bucket method” to determine alfalfa weevil larval
Procedures for using the six-stem survey to estimate alfalfa weevil larval densities.
By Scott Schell, entomologist
Walk into the field at last 20 steps from the field border, look toward the horizon as you walk into the field (do not look at the plants).
At the first stop, bend over while still looking at the horizon and grasp the base of an alfalfa stem.
Cup the stem tip and gently break it from the crown.
Place the stem, tip first, into a 3-gallon bucket.
Straighten up, fix your gaze on the horizon, turn in any direction, take one to three steps, bend over while still looking at the horizon, and randomly select another stem. Collect this stem in the same manner as the previous one.
Repeat step five until six stems have been collected at the sample site.
Grasp all six stems by their bases and vigorously shake and beat them inside the bucket to dislodge larvae.
Pour contents of the bucket onto a white cloth, count the number of larvae present, and record this number.
Go to your next sampling site and repeat this procedure.
To obtain an estimate of larvae per stem for the entire field, divide the total number of larvae counted for all sampling sites by the total number of stems collected for all sampling sites.